Customers have often asked me if I sell a counter to go along with the Rees Winder.\u00a0 I have had to answer with a “yes…but…”\u00a0 The counters I have had require a lot of work on the customer’s part; including dis-assembly of the winder itself.<\/p>\n
Now, after much thinking, 4 prototypes, and over 60 hours of design and development, I have created a product that any modeler can install in under 5 minutes (how long does a drop of CA take to set up?)\u00a0\u00a0 There are two steps:\u00a0 glue a small magnet to the large gear – and – slip the counter into the winder.\u00a0 That’s it!<\/p>\n
Each item is hand made of durable, laser-cut, 1\/32″ birch plywood.\u00a0 The counter itself counts INPUT turns, so since the winder is a 10:1 winder, simply add a zero (or multiply the value x 10) and you have your turns on the motor.\u00a0 Each until takes approximately 2 hours to assemble – I do the work to make it easy for you.<\/p>\n
They are available now in the basement – look under Rubber, etc \/ Winders & Accessories.\u00a0 $30 each, complete with illustrated instructions for installation and battery replacement.<\/p>\n
Now, get crankin’!<\/p>\n
![\"VPS](\"https:\/\/volareproducts.com\/new2024\/wp-content\/uploads\/2013\/11\/Counter-000.jpg\")
VPS Counter for the Rees Winder<\/p><\/div>\n","protected":false},"excerpt":{"rendered":"
Customers have often asked me if I sell a counter to go along with the Rees Winder.\u00a0 I have had to answer with a “yes…but…”\u00a0 The counters I have had require a lot of work on the customer’s part; including … Continue reading