VPS Peanut Corsair 3D Printed Prop


You cannot Add to Cart until you
Login First


Designed for Scale appearance.  As proven on my Peanut Corsair.

Recommended for a ~9-10 gram model flying on a loop of 3/32″ rubber.

Printed in heat resistant ABS.  These props come with a basic clean-up performed.  They are close to balanced, generally requiring no extra work.

Pre-sale preparation:  these props take about 1 hour to print and about 15 minutes to manually clean up (light scraping and sanding) to get them ready for sale.

These props come with a NOMINAL 1/16″ shaft hole.  This allows the user to bush it appropriately for their prop shaft.

These props DO NOT HAVE A RAMP.  This allows the user to install their favorite clutch.  I recommend a Garami-style or a Boehm-Style clutch.

A Garami-style clutch should utilize a Tube-In-Tube prop shaft.  A Boehm-style clutch only needs one Tube bushed into the prop.

  • Diameter – 5″
  • Pitch – 6.5″
  • Spinner – no spinner for the Corsair
  • Weight – ~1.7 grams
  • Recommended Rubber – 1 loop 3/32″


  • 3-Blade
  • 4-Blade
    Note: the 3-blade and 4-blade have approximately the same total blade area, so they should fly in a similar manner
  • Black (standard color)
  • Gray


Additional information

Weight .25 oz
Dimensions 5 × 5 × .25 in

3-blade, 4-blade


Black (standard), Gray


There are no reviews yet.

Be the first to review “VPS Peanut Corsair 3D Printed Prop”

Your email address will not be published. Required fields are marked *