Back in 1998, I built a little Barracuda Peanut. The plan appeared in the Cleveland Free Flight Society’s “Crosswinds” newsletter. It was a great flyer right off the board; my records show that I won 7 kanones with it that year, in Peanut and WWII, before it was lost OOS in Flint.
After my previous post about my Stuka and how I really should build another – better performing – WWII plane, I dug out the old plans, modified them and laser cut some parts out of 1/32″ sheet and 1/20″ sheet. The largest dimensional wood in this model is 1/16″ square for the leading edges.
With a bit of trimming, this should be a great flyer; it already does about 3 left-hand circuits on 500 turns of a single loop of 1/16″ rubber. With a bit of LUCK, I’ll keep it around for awhile, but I expect it will also go OOS before the end of the year.
It is 10 grams without rubber, and still needs a tail wheel and radio antenna and wire. All color and decoration was printed onto white Esaki. Laser cutting started on 30 May and the test flights were yesterday (but I did wait about 3 days to make a canopy).
See the full gallery here: https://volareproducts.com/blog/?page_id=1541
4,461 total views, 4 views today